UPLOAD INSTRUCTIONS FOR EACHINE PRO58 In order to upload the new Firmware you need a tool called ST-Link and the STM32 ST-LINK utility If you are sure that you want to use ACHILLES PLUS For Eachine PRO58 ,Please follow those steps. STEP 1 In order to upload the new Firmware you […]
Instructions
4 posts
When you successfully upload AchilleΣ PLUS on Eachine Pro58 You have to follow these 5 Steps Power up your Module (without Antennas On) , it will automatically factory reset , and Calibration procedure is going to begin. Open a VTX (With Antenna!!) and set it at 25MW power Hold […]
1. download the Xloader http://russemotto.com/xloader/XLoader.zip set your FTDI to 5V. Device: Duemilanove/Nano(ATmega328) Baud Rate: 57600 2. Upload the eeprom_clear.hex to the RealAcc (This is important step You have to reset chip first.) 3. Upload the Achilleas_Vxx.hex to the RealAcc 4. Calibration. For best Results Use a 25mw tx and leave 1 or […]